If you have an automatic garage door opener, you should be inspecting it at least once every three months. You might not realize this, but waiting too long to inspect your garage door opener could put you at risk for some serious problems. Some people only inspect their garage door openers once or twice a year, but that's just not often enough, especially when it comes to your safety and the safety of your family. Here are four steps you should take you should take every three months to ensure that your garage door opener is in good working order.
Inspect the Springs
When it comes to inspecting your garage door opener, you need to start with the springs. Garage door springs are coiled tightly and are under extreme pressure. When they give way, they release with such force that they can cause serious bodily injury. To avoid catastrophic injuries, you should inspect the torsion springs and the overhead extension springs at least once every three months. Look for signs of damage to the coils, as well as signs that the springs are bowing down, or have become over-extended. If you see signs of damage, you'll need to have your springs replaced as soon as possible.
Tighten All the Bolts and Screws
When your garage door is opening and closing, the entire system vibrates. If you use your garage door more than a couple of times a day, your system is going to endure a great deal of vibration. Unfortunately, all that vibration can loosen the bolts and screws. When you inspect your garage door, be sure to tighten all the bolts and screws. This will prevent them from falling out and causing your garage door to collapse.
Ensure That Your Tracks are Level
The tracks that run along each side of your garage are responsible for ensuring the smooth operation of your garage door. If the tracks aren't level, your garage door won't open properly. To make sure that your garage door is level, you should test it each time you inspect your garage door opener. Using a torpedo level, check to make sure that your tracks are in balance. If the level doesn't bubble, you'll need to have your garage door repair technician come out and adjust your tracks.
Test the Reverse Mechanism
When it comes to the safety of your family, the most important thing you can do is test the reverse mechanism on your garage door opener. The reverse mechanism will stop the door from closing all the way if it detects something in the way of the sensors. However, if the reverse mechanism isn't working properly, the garage door will continue to close, which could result in a crushing injury or fatality. To check the reverse mechanism, place a block of wood on the garage floor, directly in line with the garage door, and press the button to close the garage door. The garage door should stop in its tracks and reverse as soon as it comes in contact with the wood. If it doesn't, disconnect the garage door and call your repair technician immediately. Don't use the door until it can be repaired.
To learn more, contact a garage door company like Callahan Door and Window.